THE LUMA-LOCK SYSTEM is designed to suspend services from a single point suspension. The aim of this support is to reduce the amount of material that is used to build a support. Luma-Locks are fitted to the intended application using toggles and then coupled to a chosen Zip-Clip vertical suspension to hang from a variety of different base materials. THE APPLICATIONS SUITABLE AREAS OF USE INCLUDE, BUT ARE NOT LIMITED TO: Long cable tray runs. Off-shoots from the main containment. Light fittings. Radiant heat panels. Chilled beams. Acoustic boards. Plenum boxes. Long suspensions up to 10 m. AREAS FOR USE The Luma-Lock system is designed for indoor applications. Regular galvanised systems should not be used in areas that have levels of corrosion or elevated levels of heat or moisture. For installations that are within corrosive areas consult with Zip-Clip Technical Department. INSTALLATION Example installation into a light fitting: STEP 1: Select the first leg to be installed and position the toggle approx. 10 mm from the stop-end. Invert the toggle so it is parallel with the wire rope. STEP 2: Place the stop-end into the selected through hole and then push the toggle into the hole. Repeat the process for the other leg. Once the toggle and stop-end have been installed, the toggle will swing through 90 degrees to span the hole. Example installation connection with the wire support: STEP 1: Offer the Luma-Lock up to a pre-installed wire support. Feed on Zip-Clip locking device and pull through the required length of wire and feed through the loop of the Luma-Lock. STEP 2: Return wire back up into Zip-Clip locking device and when the desired height is achieved, trim wire leaving a minimum 15 cm tail.